HP-UX Virtual Partitions Ordering and Configuration Guide (May 2012)

• Added Warning regarding Ignite-UX and A.04.01on PA-RISC systems. Requires an Ignite-UX
version earlier than C.6.8 or vPars A.04.02 or later.
• Added iCAP v8.x requirement (not a vPars requirement) for Dual-core Intel® Itanium®
(Montecito) processors.
Version 06.12.15
• Highlighted the existing statement regarding the maximum number of cells per nPartition (8)
as well as the maximum number of virtual partitions per nPartition (8).
• Added specific Dual-core Intel® Itanium® (Montecito) processor information.
Version 06.10.01
• Highlighted the statement regarding the maximum number of virtual partitions per nPartition.
Version 06.09.01
• Finalized for vPars A.04.03 release.
Version 06.06.01
• Added rx8640 SEU/IOX support to SEU/IOX list.
• Simplified WLM and iCAP version requirements.
• Added information on vPars A.04.03 release (tape device support).
Version 06.03.16
• rx7640/8640 required system firmware for the sx2000 chipset added.
• Corrected End of Support Date for vPars A.04.02 to the year 2008.
Version 06.03.07
• Additions for vPars A.04.02.
Version 06.01.15
• PHKL_31227 is required for cards that have a PCI-to-PCI bridge. This includes the cards
AB290A, A9782A, A9784A, and AB465A. See “Supported Mass Storage and Networking
Cards (PA-RISC)” (page 32).
Version 06.01.01
• Secure Path Installation Sequence for vPars A.04.01.
• Updated End of Support Date for vPars A.04.01 (now based on the required firmware release
rather than only the software release).
• Added Web Download instructions for all HBAs on Integrity servers.
• Updated feature name to Flexible Administrative Capability (previously named Primary-Admin
vPars Security).
• Removal of information for unsupported vPars releases.
• New versioning and formatting of this document.
8 Introduction to This Document