HP Virtual Connect Enterprise Manager 6.3 CLI Guide

Table 32 VCEM server error messages and descriptions (continued)
Error message descriptionError message number
The target server bay is already in use by another server
profile.
2604
The target server bay does not exist or does not belong to
the same VC Domain Group that the server profile belongs.
2605
In the FC SAN connection for interconnect bay , the entered
boot target WWPN is not well formed. Valid format is
xx:xx:xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx-xx-xx or
xxxxxxxxxxxxxxxx where each x represents a hexadecimal
digit.
2606
In the FC SAN connection for interconnect bay , the
specified boot target LUN is invalid. Valid values are either
a 3-digit decimal between 0 and 255, or a 13- to 16-digit
hexadecimal between 0 and FFFFFFFFFFFFFFFF.
2607
Cannot set SAN boot settings because the specified boot
priority is not valid.
2608
Cannot create server profile because the specified server
profile does not contain the minimal required information.
Verify the server profile has: - A unique name - A VC
Domain Group - At least two Ethernet network connection
physical ports defined - One FC SAN connection physical
port defined for each available FC SAN fabric module -
SAN boot settings for each FC SAN connection physical
port
2609
There are missing or duplicate Ethernet network
connections. A continuous sequence finishing on the last
valid Ethernet network connection port is required.
2610
The specified VC Domain Group does not exist. A server
profile must be assigned to an existent VC Domain Group.
2611
Cannot perform server profile assignment because the
specified VC Domain has an expired license. Apply a
permanent license and then perform the operation again.
2612
Cannot perform server profile assignment because the
target Server Bay is already in use by another server
profile.
2613
Cannot perform the Server Profile operation because there
is a server bay with a server powered up. Verify that all
servers involved in the operation are powered down, and
then perform the operation again.
2614
Cannot perform server profile assignment because the
specified target Server Bay is not valid. Verify the specified
target Server Bay belongs to a managed VC Domain.
2615
Cannot perform server profile assignment because the
server profile is already assigned to another Server Bay.
The assignment was triggered explicitly, or this profile was
either (a) failed over, (b) moved, or (c) edited.
2616
Cannot perform server profile unassignment because an
exception occurred.
2618
Cannot perform server profile unassignment because the
specified server profile is not currently assigned to a server
bay.
2619
73