HP Virtual Connect Enterprise Manager 6.3 CLI Guide

Table 32 VCEM server error messages and descriptions (continued)
Error message descriptionError message number
Cannot perform the operation because the VC Domain
maintenance is not completed. Perform these steps: 1. Go
to the VCEM - VC Domains tab and select the VC Domain
that is under maintenance. 2. Click VC Domain
Maintenance. 3. Click Complete VC Domain Maintenance
to apply the configuration changes to the entire VC Domain
Group, or click Cancel to not apply changes and restore
the current VC Domain Group configuration to the VC
Domain. Verify that the VC Domain maintenance operation
was completed or canceled with success, and then perform
the operation again.
2620
The number of FC SAN connections is incorrect.2625
In the FC SAN connection for interconnect bay , the range
type is not compatible with the addresses inside the
connection.
2626
A server profile cannot have less than two Ethernet network
connections. At least two Ethernet network connection
physical ports are required.
2627
In the FC SAN connection for interconnect bay , the
connection was replaced by a new one. To replace a
connection by a new one, first edit the profile and delete
the connection, then edit the server profile again and add
a new connection.
2628
It was not possible to remove the provided vNet mapping
from the server profile.
2629
The target server bay does not support server profiles.
Verify the device in the server bay is supported by VC
Manager.
2630
Specified Server Bay ID does not correspond to a managed
server profile in VCEM.
2632
Cannot perform server profile move because the specified
server profile was already moved from Server Bay on VC
Domain .
2633
Cannot perform the server profile operation because it is
not possible to have connections with different address
types in the same server profile.
2636
The target server is powered up. The operation requires
the server to be powered down.
2639
In the ethernet connection for port , the range type is not
compatible with the addresses inside the connection.
2640
In the ethernet connection for port , the connection was
replaced by a new one. To replace a connection by a new
one, first edit the profile and delete the connection, then
edit the server profile again and add a new connection.
2641
There are more than one FC SAN connections configured
as secondary SAN boot. Only one FC SAN connection
can be configured as secondary SAN boot.
2643
There is one FC SAN connection configured as secondary
SAN boot, but no one configured as primary SAN boot.
2644
There are missing or duplicate FC SAN connections. A
continuous sequence finishing on the last valid FC SAN
connection port is required.
2645
74 Error messages