HP BladeSystem c-Class Virtual Connect Support Utility Version 1.9.1 Release Notes

Issues and workarounds 6
• Resolved CVE 2014-0160 Heartbleed issue.
The following issues are resolved in VCSU 1.9.0:
• VCSU and HPSUM failed to update VC firmware if VLAN is configured for OA and interconnect
modules, and another non-VC interconnect module is installed.
• Users were unable to use the DNS Name of the OA to run a health check or update firmware, and could
only use an IP address.
Issues and workarounds
Issues
None.
Prerequisites
• IMPORTANT: If you have FCoE connections configured through a mezzanine card, see Customer
Advisory c02950493 on the HP website
(http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c02950493) for
information required to avoid a temporary FCoE outage during firmware update.
• VCSU supports IPv4 addresses. To support IPv6, the managed enclosures/servers require OA and iLO
from SPP 2013.09.0 (B) or higher SPP releases to be installed.
• For upgrading to VC 3.00 or later, the embedded Virtual Connect GUI and CLI FW update options
have been removed. VCSU is the only standalone method of FW update.
• HP strongly recommends running the healthcheck option on an enclosure before performing any
management tasks. These tasks include, but are not limited to, the following:
o Onboard Administrator firmware upgrade
o Virtual Connect firmware upgrade
o Onboard Administrator planned failover
o Virtual Connect planned failover
• When entering an OA user name from a Linux command shell with the domain\username format, use
quotation marks around the username so it is not expanded by the Linux shell.
Example:
vcsu -a collect -i 128.88.142.141 -u "dvt\ldapuser" -p hp123
• When entering an OA user password interactively with password masking from a Linux command shell,
use quotation marks around the asterisk so it is not expanded by the Linux shell.
Example:
vcsu -a version -i 192.168.1.100 -u Administrator -p "*"
OA Password:***********