HP BladeSystem c-Class Virtual Connect Support Utility Version 1.7.1 Release Notes
Resolved issues 8
Resolved issues
The following issues that existed in previous versions of Virtual Connect Support Utility have been resolved in
Virtual Connect Support Utility Version 1.7.1:
• Resolved an issue where VCSU 1.7.0 and earlier might abort the firmware upgrade process at 40%
due to a defective or invalid iLO state on one or more server blades and leave a VC Ethernet module
with a status of "Update Failed." The VCSU log reports these failures under the following conditions:
o [VcsuCore.cpp:3411] : Fail over to backup module failed
o [VcsuProgress.cpp:1222] : Failover not successful to activate primary module
o [VcsuProgress.cpp:1223] : Aborting further activations as this would destroy the VC Domain
configuration
o [VcsuProgress.cpp:166] : VC Enet Activation Failed
o [VcsuUpdate.cpp:626] : Firmware update failed on one or more modules
• Resolved an issue where VCSU appeared to hang during firmware activation.
• Resolved an issue where VCSU failed to update in a no domain environment in which modules were in
higher numbered bays and new modules were inserted into lower numbered bays.
• Resolved an issue where VCSU failed to activate in a no domain environment for bays 3 and 4 when
bay 1 had a VC module installed and bay2 did not have a VC module installed.
• Resolved an issue where VCSU did not validate user privileges before performing the update.
• Resolved an issue where VCSU returned a 0 exit code for a failure condition and the modules were not
being updated.
• Resolved an issue where VCSU would generate an exception if a password longer than 256 characters
was used for the Configuration Backup Password option.
• Resolved an issue where VCSU would fail to activate when the VC version was first updated to VC 3.70,
and later downgraded to VC 3.18.