HP WebQoS for HP-UX Release Note

HP WebQoS on HP-UX

Installing HP WebQoS

Chapter 1 7

Checking System Prerequisites

Before installing HP WebQoS, check that your system meets all of the necessary

prerequisites.

HP-UX Prerequisites

Computer: HP 9000 server

Operating

System: HP-UX 11.0

Memory: At least 128 MB

Disk Space: 90 MB: 80 MB to install the WebQoS bundle and at least 10 MB for working

ﬁles

Web Server: iPlanet Web Server 4.1 SP2 or Zeus Web Server 3.3.6 (For HP LocalDirector

Controller, you can also use Netscape FastTrack Server version 3.0 or later)

Kernel

parameters: Kernel parameters are described in the manual Conﬁguring HP WebQoS on

HP-UX. After installing WebQoS, the manual is in the following location:

/opt/webqos/docs/install_config_guide.pdf.

Other: For HP LocalDirector Controller, Cisco LocalDirector version 2.1 or later.

PC Prerequisites

Operating

System: Windows 95, 98, or NT 4.0

Memory: At least 64 MB

Disk Space: 17 MB for the management user interface, 3 MB for HP OpenView Service

Reporter integration

Upgrading to WebQoS 2.2

If you are upgrading from a previous version of WebQoS, you need to run the following

command before you install WebQoS 2.2:

/opt/webqos/install/setup -r

Then follow the instructions in “Installing the WebQoS Software” in this release note to

install WebQoS 2.2. Do NOT remove your earlier WebQoS version. Otherwise, your

conﬁguration data will be lost. Your existing management data is preserved when you install

the new software. After installing WebQoS 2.2, run

/opt/webqos/install/setup