DisplayMaker Legacy ColorMark+ - User Guide

Creating Profiles 2-3
Preparation 1. Load the combination of media and ink that you want to
profile.
2. Perform an AutoSet calibration (for DisplayMaker, except
FabriJet). Getting the cartridges properly aligned and jets
mapped as needed is essential to creating an accurate pro-
file.
Refer to the printer’s User Manual for instructions.
3. Calibrate the DTP41 or DTP41T. (The GretagMacBeth
Spectrolino does not need calibration.)
4. From the System Control interface on the server, right-
click a printer icon to open the icon menu.
5. From the printer icon menu, select Create...
The ColorMark+ software launches. The Select Ink Type dia-
log box appears. It displays the ink set(s) detected in the
printer.
Select Ink and Media 6. From the Select Ink Type dialog box:
◆ Click Next to accept the ink shown, or
◆ Select the other ink type from the drop-down list, or
◆ Click Cancel to exit and load a different ink type in the
printer.
Fig. 2-1. Select Ink Type