HP RIP Software - HP RIP Software User Guide

1-20 Installation
To use TCP/IP:
1. Log in to Windows.
2. Click Start - Settings - Printers and Faxes to open the Printers
folder.
The Printers folder appears.
3. Click Add Printer to launch the Add Printer Wizard.
The Add Printer Wizard opening dialog box appears.
4. Click Next.
The Local or Networked Printer dialog box appears.
5. Select Local Printer, and make sure that “Automatically detect and
install my plug and play printer” checkbox is NOT checked.
6. Click Next.
A dialog box with a list of ports appears.
7. Click the Create a new port radio button.
8. In the drop-down menu, select Standard TCP/IP Port and click
Next.
This starts the Add Standard TCP/IP Printer Port Wizard.
9. Click Next.
The Add Port dialog box appears.
10. Enter the IP address of the TCP/IP port you created on the RIP.
11. Replace the default port name with the name of the port you
assigned when you created it on the RIP.
12. Click Next.
The Additional Port Information Required dialog box appears.
13. Click the Custom radio button, then click the Settings button.
14. Verify and change, if needed, the port name and IP address.
15. In the Protocol section, click the LPR radio button.
16. In the LPR settings section, enter the name you gave the
TCP/IP port.