HP XC System Software Administration Guide Version 3.2

column of the Nagios Service Detail View and Service Problems View windows.
Figure 8-4 (page 111) and Figure 8-6 (page 113) show an example of these windows, respectively.
Table 8-2 Monitored Nagios Services
FunctionNagios ServiceCategory
This plug-in updates node configuration. It periodically
generates and updates configuration display information
for all nodes in the HP XC system (see Configuration).
Configuration MonitorMonitoring Plug-Ins
Enclosures for HP Blade systems are represented as hosts
in nagios web interface. The check_enclosures
plug-in alerts you if sensor data for the enclosures is
outside its operational range. Updates to the
/opt/hptc/supermon/bin/sensors script collect
environmental data for enclosures.
Enclosure Monitor
This plug-in watches the LSF master daemon and reports
its status. It causes LSF failover if required.
LSF Failover Monitor
This plug-in watches the Nagios master and Nagios
monitor nodes. It reports on the status of the Nagios
master and monitor daemons across the HP XC system.
Nagios daemons run only on service nodes. Smaller
systems might have only a single master on the head
node.
Nagios Monitor
This plug-in examines node status asynchronously and
stores the results (using attributes) in the CMDB.
You can invoke this plug-in from the command line to
determine the node status (that is, up or down) as
follows:
# /opt/hptc/nagios/libexec/check_node
-list
Host Monitor
This plug-in collects and gathers resource (squeue)
information for this monitor/masters set of managed
nodes (domain). Individual node status is displayed
through the Resource Status Nagios service.
Resource Monitor
This plug-in monitors an attached SFS appliance.SFS Monitor
This plug-in collects, gathers, and reports resource
(sinfo) information for this monitor/masters set of
managed nodes (domain). Individual node status is
displayed through the SLURM Status Nagios service.
SLURM Monitor
This plug-in gathers (predetermined) supermon metrics
for this monitor/masters set of managed nodes (domain).
This plug-in collects loadave, environmental, node
information data and stored to the CMDB.
Supermon Metrics Monitor
This plug-in watches for patterns in the
/opt/hptc/nagios/etc/syslogAlertRules file.
Individual per-node results are reported by the Syslog
Alerts Nagios service.
Syslog Alert Monitor
8.4 Configuring Nagios on HP XC Systems 121