HP XC System Software Administration Guide Version 3.2

esac

# cat lsf.csh

if ( "${path}" !~ *-slurm/etc* ) then

if ( -f /opt/hptc/lsf/top/conf/cshrc.lsf ) then

source /opt/hptc/lsf/top/conf/cshrc.lsf

endif

The goal of these custom files is to source (only once) the appropriate LSF environment

file: $LSF_ENVDIR/cshrc.lsf for csh users, and $LSF_ENVDIR/profile.lsf for

users of sh, bash, and other shells based on sh.

Create /etc/profile.d/lsf.sh and /etc/profile.d/lsf.csh on the HP XC

system to set up the LSF environment on HP XC. Using /shared/lsf for the value of

LSF_TOP as an example, the new files would resemble these:

# cat lsf.sh

case $PATH in

*-slurm/etc:*) ;;

*:/shared/lsf/*) ;;

if [ -f /shared/lsf/conf/profile.lsf.xc ]; then

. /shared/lsf/conf/profile.lsf.xc

esac

# cat lsf.csh

if ( "${path}" !~ *-slurm/etc* ) then

if ( -f /shared/lsf/conf/cshrc.lsf.xc ) then

source /shared/lsf/conf/cshrc.lsf.xc

endif

NOTE: The profile.lsf.xc and cshrc.lsf.xc scripts do not exist yet. We will

establish them after installing LSF-HPC with SLURM in a future step. Be sure to replace

/shared/lsf with the location of LSF_TOP on your system. Note that the names of

the setup files are appended with .xc.

After installing LSF-HPC with SLURM, rename the setup files to avoid disturbing the

existing setup files. These new custom files /etc/profile.d/lsf.sh and

/etc/profile.d/lsf.csh must be propagated to every node in the HP XC system;

this is done in an upcoming step.

Set up the HP XC LSF-HPC with SLURM Startup Script

294 Installing LSF-HPC with SLURM into an Existing Standard LSF Cluster