HP XC System Software Hardware Preparation Guide Version 3.1

Table 3-14 BIOS Settings for HP ProLiant DL145 G2 Nodes (continued)
Set To This ValueOption NameSubmenu NameMenu Name
Disabled
BIOS POST WatchdogIPMI
Set the following boot order on all
nodes except the head node:
1. CD-ROM
2. Removable Devices
3. PXE MBA V7.7.2 Slot 0300
4. Hard Drive
5. ! PXE MBA V7.7.2 Slot 0200 (!
means disabled)
Set the following boot order on the
head node:
1. CD-ROM
2. Removable Devices
3. Hard Drive
4. PXE MBA V7.7.2 Slot 0200
5. PXE MBA V7.7.2 Slot 0300
Boot
Disabled
Wake On Modem RingPower
Disabled
Wake On LAN
4. Select Exit → Save Changes →Exit to exit the BIOS Setup Utility.
5. Repeat this procedure for every HP ProLiant DL145 G2 node in the hardware configuration.
3.6.3 Preparing HP ProLiant DL385 Nodes
On HP ProLiant DL385 servers, use the following tools to configure the appropriate settings for an HP
XC system:
• Integrated Lights Out (iLO) Setup Utility
• ROM-Based Setup Utility (RBSU)
Figure 3-9 shows a rear view of the HP ProLiant DL385 server and the appropriate port assignments for
an HP XC system.
Figure 3-9 HP ProLiant DL385 Server Rear View
3
1
2
HPTC-0145
3
1 3 3
M H z
1
100
M H z
2
1 0 0
M H z
The callouts in the figure enumerate the following:
Setup Procedure 49