HP XC System Software Installation Guide Version 3.1

Password# 123456

5. Access the enable mode with the default password (voltaire):

ISR-9024# enable

Password# voltaire

6. Change the default admin password:

ISR-9024# password update admin

7. Change the default enable password:

ISR-9024# password update enable

8. Access the configuration mode:

ISR-9024# config

9. Access the interface fast mode:

ISR-9024(config)# interface fast

10. Set the IP address of the switch and the netmask using the data in Table D-4 as a reference. Set the

netmask to 255.255.0.0 as shown:

ISR-9024(config-if-fast)# ip-address-fast set IP_address 255.255.0.0

11. Confirm the settings:

ISR-9024(config-if-fast)# ip-address-fast show

12. Exit the interface fast mode:

ISR-9024(config-if-fast)# exit

13. Access the route mode:

ISR-9024(config)# route

14. Set the gateway IP address, which is the internal IP address of the head node:

ISR-9024(config-route)# default-gw fast set IP_address

15. Confirm the gateway IP setting:

ISR-9024(config-route)# default-gw show

16. Exit the route and configuration modes:

ISR-9024(config-route)# exit

17. Enable the switch to generate error reports:

ISR-9024(config)# sm

ISR-9024(config-sm)# pm

ISR-9024(config-sm-pm)# pm report-enable set enable

ISR-9024(config-sm-pm)# pm reset-counters set

ISR-9024(config-sm-pm)# exit

ISR-9024(config-sm)# exit

128 Configuring Interconnect Switch Monitoring Cards