HP XC System Software Installation Guide Version 3.1

H Determining the Network Type
The information in this appendix applies only to cluster platforms with a QsNet
II
interconnect.
During the processing of the cluster_config utility, the swmlogger gconfig script prompts you to
supply the network type of the system. The network type reflects the maximum number of ports the switch
can support, and the network type is used to create the qsnet diagnostics database. The QsNet
II
diagnostic
database utilities will not work properly if you specify an incorrect network type.
QsNet
II
currently supports the following network types: QMS8, QMS16, QMS32, QMS64, QMS128, QMF256,
and QMF1024, where the digits represent the maximum number of ports.
Follow this procedure to determine the network type:
1. View the following file to determine the NumLevels value:
# cat /proc/qsnet/elan4/device0/position
NodeId 7
NumLevels 2
NumNodes 16
2. Use the information shown in Table H-1 to determine the network type based on the NumLevels
value you obtained in the previous step and the maximum number of ports in the switch.
Table H-1 Network Type Based on System Topology
Network TypeNumLevels Value
QMS81
QMS162
QMS322
QMS643 (this is a 64-way full bandwidth system)
QMS1283 (this is a 128-way reduced bandwidth system)
QMF2564
QMF10245
151