HP XC System Software Installation Guide Version 3.1

Virtual hostname is lsfhost.localdomain
Comparing ncpus from Lsf lshosts to Slurm cpu count.
The Lsf and Slurm cpu count are in sync.
+++ PASSED +++
Testing hosts_status ...
Running 'bhosts -w'.
Checking output from bhosts.
Running 'controllsf show' to determine virtual hostname.
Checking output from controllsf.
Virtual hostname is lsfhost.localdomain
Comparing MAX job slots from Lsf bhosts to Slurm cpu count.
The Lsf MAX job slots and Slurm cpu count are in sync.
+++ PASSED +++
Verify interconnect:
Testing infiniband/monitoring_line_card_setup ...
+++ PASSED +++
Testing infiniband/port_state ...
Collecting vstat data from all enabled nodes...
Nodes with a good port_state of PORT_ACTIVE: n[3-16]
+++ PASSED +++
Verify nagios:
Testing configuration ...
Running basic sanity check on the Nagios configuration file.
Starting the command:
/opt/hptc/bin/nagios -v /opt/hptc/nagios/etc/nagios_local.cfg
Here is the output from the command:
Nagios 2.3.1
Copyright (c) 1999-2006 Ethan Galstad (http://www.nagios.org)
Last Modified: 05-15-2006
License: GPL
Reading configuration data...
Running pre-flight check on configuration data...
Checking services...
Checked 158 services.
Checking hosts...
Checked 16 hosts.
Checking host groups...
Checked 13 host groups.
Checking service groups...
Checked 0 service groups.
Checking contacts...
Checked 1 contacts.
158 OVP Command Output