HP XC System Software Installation Guide Version 3.1

You must now specify the clock source for the server nodes. If the
nodes have external connections, you may specify up to 4 external NTP
servers. Otherwise, you must use the node's system clock.
Enter the IP address or host name of the first external NTP server
or leave blank to use the system clock on the NTP server node: IP_address
Enter the IP address or host name of the second external NTP server or
leave blank if you have no more servers: Enter
Renaming previous /etc/ntp.conf to /etc/ntp.conf.bak
4. Supply the network type if the system has a QsNet
II
interconnect; the possible choices for the system
are displayed, and a default is provided:
Enter the network type of your system.
Valid choices are QMS16 or QMS32: [QMS32]: Enter
The network type reflects the maximum number of ports the fabric topology can support. See
Appendix H (page 151) for information about how to determine the QsNet
II
network type for the
system.
5. Specify how many node-level and top-level switches are in the system configuration if the system
has a QsNet
II
interconnect:
Enter the number of node level switches in your configuration [1-32]:
Enter the number of top level switches in your configuration [0-32]:
6. If you have configured the dbserver service for improved availability, you are prompted to specify
how you want to configure improved availability. If you have not configured an availability set with
this service, bypass this step and proceed to the next step.
Executing C10hptc_cluster_fs gconfigure
Executing C12dbserver gconfigure
Availability can be configured for dbserver in one of several ways.
The choices are:
1: standard
2: serviceguard
A choice of 'standard' (1) means no improved availability.
Enter the number corresponding to the way to configure availability []: 2
Executing C20gmmon gconfigure
Executing C20smartd gconfigure
Executing C30syslogng_forward gconfigure
Executing C35dhcp gconfigure
Executing C42mcs gconfigure
Executing C50cmf gconfigure
Executing C50lvs gconfigure
7. Supply the name of the LVS alias if you assigned a login role to one or more nodes. This example
specifies the alias penguin and enables the LVS director for improved availability. This is the name
by which users will log in to the system. If you did not assign a login role to any node, you are not
asked to supply an LVS alias.
If you have configured the LVS director service for improved availability, you are prompted to
specify how you want to configure improved availability.
Executing C50lvs gconfigure
Enter the name of the cluster alias []: penguin
Availability can be configured for lvs in one of several ways.
The choices are:
1: standard
72 Configuring and Imaging the System