HP XC System Software Installation Guide Version 3.1

17. Provide responses to install and configure LSF. This requires you to supply information about the
primary LSF administrator and administrator's password.
The default user name for the primary LSF administrator is lsfadmin. If you accept the default user
name and a NIS account exists with the same name, LSF is configured with the existing NIS account,
and you are not be prompted to supply a password. Otherwise, accept all default answers.
Command output is similar to the following:
What name shall LSF use to uniquely identify this system?
No existing host names are allowed, and the name must be
less than 39 characters with no whitespace:
LSF System Name [hptclsf]: Enter
Enter the name of the Primary LSF Administrator. You can
configure additional administrators later, but this user
must exist now in order to be given ownership of the files
to be installed. If this user does not exist, it will be
created locally [lsfadmin]: Enter
The lsfadmin user does not exist. Do you want to
create this user now? (y/n) [y] Enter
Changing password for user lsfadmin.
New UNIX password: your_lsfadmin_password
Retype new UNIX password: your_lsfadmin_password
passwd: all authentication tokens updated successfully.
Executing the Platform LSF-HPC installation script (hpcinstall)...
Logging installation sequence in /opt/hptc/lsf/files/lsfslurm/
install-20060925114531/lsf6.2_lsfinstall/Install.log
1) linux2.6-glibc2.3-x86_64-slurm
Press 1 or Enter to install this host type: Enter
1
1
The sample command output was obtained from an HP ProLiant server. The tar file name
is linux2.6-glibc2.3-x86_64-slurm (the string x86_64 signifies an Opteron or Xeon
chip architecture). The string ia64 is included in the file name for HP Integrity servers.
18. Follow along with the remainder of the system configuration process. This sample output is provided
for your information only; there is nothing else you have to do in this step. Despite some of the
messages shown in the command output, everything you need to install, configure, and verify LSF
and SLURM is described in this document.
Pre-installation check report saved as text file:
/opt/hptc/lsf/files/lsfslurm/install-20060925114531/
lsf6.2_lsfinstall/prechk.rpt
.
... Done LSF pre-installation check.
... Done installing lsf binary files "linux2.6-glibc2.3-x86_64-slurm".
... LSF configuration is done.
lsfinstall is done.
To complete your lsf installation and get your
cluster "hptclsf" up and running, follow the steps in
"/opt/hptc/lsf/files/lsfslurm/install-20060925114531/
lsf6.2_lsfinstall/lsf_getting_started.html".
3.11 Task 10: Respond to Configuration Questions 77