HP XC System Software Installation Guide Version 4.0

an LDAP database by opening another shell in another console.
When you are done, press Enter to continue: Enter
16. Supply the name or IP address of the external NIS master server and the NIS domain name
if you assigned the nis_server role to one or more nodes to configure them as NIS slave
servers. If you did not assign a nis_server role to any node, you are not asked to supply
this information.
Executing C60nis gconfigure
Network Information Service (NIS) Configuration
This step sets up one or more NIS servers within the XC system
that are "slaves" to an external NIS "master". The master NIS
server provides the slaves with copies of its NIS maps.
In order to successfully complete this configuration step, the NIS
master must have been previously set to allow slaves to communicate
with it. On Linux systems, this is typically accomplished by adding
the NIS slave hostname(s) to the /var/yp/ypservers file on the NIS
master, and then running 'make'.
In addition, to complete this configuration, you will need to provide
1) the name or IP address of the NIS master, and
2) the NIS domain name hosted by the NIS master
Enter the name or IP address of the external NIS master: []
Enter the NIS domain hosted by the NIS master: [] your_NIS_domain
17. Specify if you want to configure the kernel dump service to store kernel crash dumps and
where you want to store the dumps. The crash dump storage location must already exist
and must be mounted.
Also, specify how you want to configure availability of the kernel dump service if you have
assigned the avail_node_management role to the nodes in an availability set. If you have
not configured an availability set with this service, omit this step and proceed to the next
step.
Executing C66ibmon gconfigure
Executing C80sfs gconfigure
Executing C85sim gconfigure
Executing C90munge gconfigure
Executing C91swmlogger gconfigure
Executing C95hpwdt gconfigure
Executing C95kdump gconfigure
Do you want to configure kernel dump support (y/n)? []:
Enter the mount point for storing the crash dumps []:
Specify how to configure availability for kdump:
1: standard (no improved availability)
2: serviceguard (use this tool for improved availability)
Enter the number that corresponds to the availability method you want to use (1/2) [1]:
18. Decide whether you want to configure SLURM. SLURM is required if you installed SVA
and if you plan to install LSF with SLURM.
Executing C90munge gconfigure
Executing C90slurm gconfigure
Do you want to configure SLURM? (y/n) [y]:
Do one of the following:
• If you intend to install LSF with SLURM or if you intend to install the Maui Scheduler,
or if you have already installed SVA, enter y and proceed to step 19.
• If you intend to install standard LSF do not install SLURM and enter n. Proceed to step
20.
6.5 Responding to cluster_config Questions 111