HP XC System Software Installation Guide Version 4.0

12 nodes -> n[2-6,8-14]
Fri Dec 05 09:06:48 2008 Processing completed for: 1 node -> n1
Fri Dec 05 09:07:03 2008 Processing completed for: 1 node -> n7
Fri Dec 05 09:07:18 2008 Processing completed for:
9 nodes -> n[4-5,8-14]
*** Fri Dec 05 09:07:33 2008 Current statistics:
Booted and available: 15 nodes -> n[1-15]
Progress:
Fri Dec 05 09:07:33 2008 Processing completed for:
3 nodes -> n[2-3,6]
*** Fri Dec 05 09:07:33 2008 Current statistics:
Booted and available: 15 nodes -> n[1-15]
Progress:
Fri Dec 05 09:07:34 2008 startsys process exiting with code 0
3
1
Watch the screen carefully for the message You must manually power off
the following nodes. This message means that you must go to the specific
node and press the power button to turn off power to the node. After doing so,
return to the screen and press the Enter key.
2
Watch the screen carefully for the message You must manually power on
the following nodes. This message means that you must go to the specific
node and press the power button to turn on power to the node. After doing so,
return to the screen and press the Enter key.
3
The message exiting with code 0 indicates successful completion.
6. If you have configured the kdump service, reboot all nodes except the head node to activate
the kdump code.
See Section 14.3 (page 178) if you encounter problems during the node imaging process.
6.8 You Are Done with Configuration and Imaging Tasks
You are done with configuration and imaging tasks. Now, go to Chapter 7 (page 123) for a list of
postconfiguration tasks you might need to perform depending upon how the software and
hardware environment is configured.
6.8 You Are Done with Configuration and Imaging Tasks 121