HP XC System Software Installation Guide Version 4.0

# telnet cp-node_name

password: admin

3. The interface you use to change the password differs depending upon the BMC firmware

version. Thus, do one of the following:

• For BMC Firmware Version 1.03:

a. Press Esc and Shift-9 to enter the command-line mode.

b. Use the C[hange Password] option to change the console port password. The

factory default password is admin; change it to the password of your choice. This

password must be the same on every node in your system.

Lights-Out> C

Type the current password> admin

Type the new password (max 16 characters)> your_password

Retype the new password (max 16 characters)> your_password

New password confirmed.

Lights-Out> exit

• For BMC Firmware Version 1.24 or higher:

a. Press Esc and Shift-9 to enter into the command-line mode.

b. Change to the following directory:

/directory_name/-> cd map1/accounts

c. List the pre-defined users (by default, 16 users have been pre-defined):

/directory_name/-> show

d. One user at a time, use the show command until you find the first instance of the

user name admin . Start with user1 and continue executing the show command

for each user in sequential order:

/directory_name/-> show user1

/directory_name/-> show user2 {...userN}

For the purposes of this example, assume that user3 is the first instance of the

user name admin .

e. Change directory to the user directory obtained in the previous step:

/directory_name/-> cd user3

f. Set the password. Be very careful with your key strokes; there is no password

verification step:

/directory_name/-> set password=your_password

g. Exit from the interface:

/directory_name/-> exit

4. Repeat this procedure to change the console management device password on every HP

ProLiant DL140 and DL145 server in the hardware configuration.

5. Rerun the discover command with the same options.

4.7 Changing the IP Address on MPs

This task applies only to CP6000 hardware configurations with HP Integrity servers.

A known limitation exists with the management processor (MP) firmware that causes the MP

to automatically disable DHCP.

To work around this issue, the HP XC software performs the discovery phase with DHCP enabled.

You must then perform a procedure to change the addresses on all MPs in the system to use the

address received from DHCP as a static address.

4.7 Changing the IP Address on MPs 75