HP XC System Software Release Notes for Version 4.0

4 Software Installation on the Head Node
This chapter contains notes that apply to the HP XC System Software Kickstart installation
session.
4.1 Manual Installation Required for NC510F Driver
The unm_nic driver is provided with the HP XC software distribution, however, it does not
load correctly.
If your system has a NC510F 10 GB Ethernet card, run the following commands to load the driver:
# depmod -a
# modprobe -v unm_nic
Then, edit the /etc/modprobe.conf file and specify unm as the driver for the eth device
assigned to the NC510F driver.
4.2 Benign Messages in postinstall.log File
You can safely ignore the following messages if they appear in the /var/log/postinstall.log
log file:
• Message about OFED:
^[[33;50mUninstalling the previous version of OFED
^[[0;10m/tmp/OFED/RPMS/install.sh: line 190: ./uninstall.sh: No such file or
directory
• Cannot open directories:
libibumad-devel ##################################################
ib-bonding ##################################################
FATAL: Could not load /lib/modules/2.6.18-53.1.21.el5/modules.dep: No such file
or directory
WARNING: Couldn't open directory /lib/modules/2.6.18-53.1.21.el5: No such file
or directory
FATAL: Could not open /lib/modules/2.6.18-53.1.21.el5/modules.dep.temp for
writing: No such file or directory
error: %post(ib-bonding-0.9.0-2.6.18_53.1.21.el5.4hp.volt2986.x86_64) scriptlet
failed, exit status 1
• Cannot open directories:
hp_qla2x00 ##################################################
Using kernel version 2.6.18-53.1.21.el5.5hp from /etc/.hp_pkinstall
No driver loaded, using failover mode
Writing new /etc/hp_qla2x00.conf...done
Modifying /etc/hba.conf
Creating /lib/modules/2.6.18-53.1.21.el5.5hp/kernel/kernel
Copying intermodule.ko to /lib/modules/2.6.18-53.1.21.el5.5hp/kernel/kernel
Saving old qla2xxx.ko
Copying qla2xxx.ko to
/lib/modules/2.6.18-53.1.21.el5.5hp/kernel/drivers/scsi/qla2xxx
Copying qla2300.ko to
/lib/modules/2.6.18-53.1.21.el5.5hp/kernel/drivers/scsi/qla2xxx
Copying qla2400.ko to
/lib/modules/2.6.18-53.1.21.el5.5hp/kernel/drivers/scsi/qla2xxx
Copying qla2xxx_conf.ko to
/lib/modules/2.6.18-53.1.21.el5.5hp/kernel/drivers/scsi/qla2xxx
Running depmod -a
WARNING: Couldn't open directory /lib/modules/2.6.18-53.1.21.el5: No such file
or directory
FATAL: Could not open /lib/modules/2.6.18-53.1.21.el5/modules.dep.temp for
writing: No such file or directory
• The following NOKEY message is benign, and all RPM packages are signed properly.
Installing HP value add RPMs
warning: /mnt/cdrom/HPC/RPMS/Crypt-SSLeay-hp-0.57-1.ia64.rpm: Header V3 DSA
4.1 Manual Installation Required for NC510F Driver 17