HP P9000 Command View Advanced Edition Suite Software 7.3.1-00 CLI Reference Guide

DescriptionStatusParameter name
Threshold2 of the THP/Smart pool (%)
The threshold2 of the THP/Smart pool is the usage rate of the
THP/Smart pool.
The following values can be specified when modifying the
threshold value:
For P9500 whose microcode version is earlier than 70-01-
4X-XX/XX:
A value cannot be specified for threshold2.
For P9500 whose microcode version is 70-01-4X-XX/XX or later:
If you specify this parameter, threshold2mode must be
set to 1.
Specify an integer in the range from 1 to 100.
You need to specify a value larger than the one specified
for threshold.
You need to specify a value larger than the one specified for
threshold.
Optional
(P9500)
threshold2
#1
Specify whether to use the value specified for threshold2 for
the THP/Smart pool.
One of the following values can be specified:
• 0: Uses the value determined by the storage system.
• 1: Uses the value specified for threshold2.
You can specify 1 only when the microcode version is 70-01-
4X-XX/XX or later.
Optional
(P9500)
threshold2mode
#1
Over provisioning warning threshold (%)
This is a threshold value related to the over-provisioning percent.
#4
The following values can be specified when modifying the
threshold value:
For P9500:
Specify an integer from 0 to 65534. You need to specify a
value smaller than the one specified for overprovi-
sioninglimit.
Specify -1 to cancel an already set threshold value.
For XP24000/XP20000:
Specify an integer from 10 to 1000. You need to specify a
value smaller than the one specified for overprovi-
sioninglimit.
Specify -1 to cancel an already set threshold value.
Optional
overprovision-
ingwarning
#1, #2,
#3
CLI Reference Guide 193