HP P9000 Command View Advanced Edition Suite Software 7.3.1-00 CLI Reference Guide

DescriptionStatusParameter name
Over provisioning limit threshold (%)
This is a threshold value related to the over-provisioning percent.
#4
The following values can be specified when modifying the
threshold value:
For P9500:
Specify an integer from 0 to 65534. You need to specify a
value larger than the one specified for overprovisioning-
warning.
Specify -1 to cancel an already set threshold value.
If you specify a threshold value and the over-provisioning
percent
#4
exceeds the specified threshold value, you cannot
create a THP/Smart volume.
For XP24000/XP20000:
Specify an integer from 10 to 1000. You need to specify a
value larger than the one specified for overprovisioning-
warning.
Specify -1 to cancel an already set threshold value.
If you specify a threshold value and the over-provisioning
percent
#4
exceeds the specified threshold value, you cannot
create a THP volume or assign THP volumes to a THP pool.
Optional
overprovi-
sioninglimit
#1,
#2, #3
Device number of the logical unit(s)
Specify this parameter as a decimal number or colon-delimited
hexadecimal number in the format ww:xx:yy, where ww is the
LDKC number, xx is the CU number, and yy is the LDEV number.
ww is optional. If ww is omitted, LDKC is assumed to be 0.
Use a comma to delimit multiple values.
Optional
adddevnums
#1, #2
Specify this parameter when you change the type of the
THP/Smart pool.
One of the following values can be specified.
• enable: Changes the pool to a Smart pool.
• disable: Changes the pool to a THP pool.
Optional
(P9500)
tiercontrol
#1,
#5
Specify whether to automatically execute performance monitoring
and hardware tier relocation.
If you specify this parameter, you must also specify
tiercontrol=enable.
This parameter can be specified when tiercontrol is set to
enable.
One of the following values fsindexcan be specified.
• enable: Performs automatic execution.
• disable: Does not perform automatic execution.
Optional
(P9500)
automigra-
tion
#1, #5
Command reference194