HP P9000 Command View Advanced Edition Suite Software 7.3.1-00 CLI Reference Guide

AddURLLink
AddURLLink allows a user to specify URL information (referred to as a URLLink) for a Device Manager
object managed by the Device Manager server.
AddURLLink is used for the following purposes:
• To specify a URLLink for an SMI-S Enabled storage system
The URL information of the software started from Element Manager of the GUI is modified. Note
that a user can set only one URLLink for each SMI-S Enabled storage system.
• To specify a URLLink to P9000 mainframe agent for a mainframe host
For a mainframe host, you can set a URLLink to the P9000 mainframe agent running on the
mainframe host. For details about how to specify the settings for managing mainframe hosts and
information on the AddURLLink command, see Appendix A on page 429.
NOTE:
This command does not support virtualization servers.
Format
When setting a URLLink for an SMI-S Enabled storage system:
hdvmcli [URL] AddURLLink [options]
url=URL name=URLLink-name
linkedid=object-ID-of-the-SMI-S-Enabled-storage-system
targetoption=smi-s
Parameters
Table 98 AddURLLink command parameters
DescriptionStatusParameter name
URL of the application or Web page
The complete URL is required to launch the application or web
page.
If you specify the URL as an IPv6 IP address, enclose the IP address
in square brackets ([ ]).
Required
url
Name of the URLLinkRequired
name
Object ID of the Device Manager object for which the URLLink is
set
Must be a valid, existing the object ID. Specify the object ID
obtained from another CLI response. The value is encoded by the
CLI.
When you specify an SMI-S Enabled storage system object ID for
the linkedid parameter, any URLLink that has already been
specified for the SMI-S Enabled storage system will be overwritten.
Required
linkedid
CLI Reference Guide 275