HP P9000 Command View Advanced Edition Suite Software 7.4.1-00 User Guide (TB581-96337, March 2013)

Reason preventing use as a migration sourceDisplayed character string
The volume is one of the following:
• The volume is part of a Continuous Access Synchronous pair, and
the status is other than PSUS, PSUE, or PAIR
• The volume is part of a Hitachi TrueCopy for Mainframe pair, and
the status is not suspended
• The volume is in an XP12000/XP10000/SVS200, and a part of a
Continuous Access Synchronous pair, and the status is PAIR
• The volume is from an XP12000/XP10000/SVS200, and part of a
Hitachi TrueCopy for Mainframe pair, and the status is Duplex
Continuous Access Synchronous
Status
Continuous Access XP Synchronous
Status
The volume is one of the following:
• The volume is part of a Continuous Access Journal pair, and the status
is either COPY or PAIR
• The volume is part of a Hitachi Universal Replicator for Mainframe
pair, and the status is either Pending duplex or Duplex
• The volume is part of a Continuous Access Journal journal volume
• The volume is a Hitachi Universal Replicator for Mainframe journal
volume
Continuous Access Journal Status
Continuous Access XP Journal Status
Auto LUN V2 is not installed in the storage system.Auto LUN V2
Migrating data for volume performance
You can migrate data based on the results of monitoring volume performance:
Tasks that must be completed beforehand:
• A Tiered Storage Manager license must be registered.
• Set up an external connection to a P9500 Disk Array, XP24000/XP20000, XP12000 Disk Array.
• Creation of a tier in which the target mainframe volumes are grouped (only when migrating
mainframe volumes).
Information that should be obtained beforehand:
• Migration source host, logical group, tier, or storage system.
• Migration target THP/Smart pools, tier or migration target volumes.
1. In the Resources or Mobility tab, select a migration source host or logical group. From a list of
hosts or logical groups, you may also select migration source volumes. If migrating data from a
mainframe volume, expand the Tiers tree on the Resources tab or the Mobility tab, and then select
the corresponding tier.
2. Click the Migrate Data button.
3. Verify that the correct migration source volumes are selected, and then click the Next button.
4. Specify the migration target, THP/Smart pool or tier and then click the Next button. When the
parity group selection rule is set, a candidate volume that is appropriate as a migration target
will be selected depending on the application that is being used or the usage rate of the parity
group. Specifically:
• Balance Capacity: System attempts to select a migration target candidate so that the remaining
capacity of the targeted parity group is equalized with other parity groups.
• Maximum Coverage: Select a candidate for the migration target from as many parity groups
as possible.
Managing storage resources in a SAN environment84