HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.0 Mainframe Agent Installation and Configuration Guide (TB581-96014, November 2010)

Restoration overwrites the entire primary volume with the entire secondary volume that contains a
backup of the primary volume. Therefore, additions and changes to the primary volume after the
backup was created are not applied.
Before executing this command, all the application programs using the volume to be restored must
be stopped. The volume being used by the operating system cannot be restored.
This command should be used to restore the primary volume to the secondary volume. This command
should not be used when the data is being backed up from the secondary volume to a tape device
with the drmmediabackup command, when the data is being restored from a tape device to the
secondary volume with the drmmediarestore command, or when the secondary volume is being
mounted with the drmmount command.
If the physical disk partition style is changed after a backup, and then the command is executed, the
command result will vary as follows.
Table 29 Physical disk partition style and the command execution result
Command execution resultAfter a backupBefore a backup
Command statusSecondary volumePrimary volumePrimary volume
Normal terminationMBR disk
MBR disk
MBR disk
Error (KAVX5171-E or KAVX5137-E
message)
After performing a resync
#1
GPT disk
Error (DRM-10337 message)
Before performing a resync
#2
MBR disk
GPT disk
Error (DRM-10337 message)
Before performing a resync
#2
GPT disk
Error (DRM-10337 message)
Before performing a resync
#2
MBR disk
MBR disk
GPT disk
Error (DRM-10337 message)
Before performing a resync
#2
GPT disk
Error (KAVX5171-E or KAVX5137-E
message)
After performing a resync
#1
MBR disk
GPT disk
Normal terminationGPT disk
#1
An error message is displayed after resynchronization is performed.
#2
An error message is displayed before resynchronization is performed.
Arguments
backup-ID
Basic commands100