HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.0 Mainframe Agent Installation and Configuration Guide (TB581-96014, November 2010)

the RAID Manager-linkage definition file (DEFAULT.dat) is set to ENABLE, the command automatically
creates a pair.
After installation, if the drmexgbackup command is executed without executing the drmexgdisplay
command with the -refresh option specified, and no dictionary map files are created, the dictionary
map files are created using the drmexgbackup command. In this case, the processing time required
to create the dictionary map files are added to the time required to execute the backup command.
Backup can only be performed for files described in the following table:
Table 44 Files backed up as targets of an Exchange Server
File to be backed up
Database to be backed
up
Option
*.edb
*.stm
#
#
Exchange Server 2007
does not use files with
this extension.
Data files
Exchange Server storage
groups
The target file type is
fixed
*.logTransaction log file
*.chkCheckpoint files
*.edbData files
Exchange Server Informa-
tion Store
The target file type is
fixed
*.logTransaction log files
*.chkCheckpoint files
Arguments
-mode cold
Specify this option to perform a cold backup by using Exchange Server 2003. Since the cold backup
dismounts the Information Store to be backed up, this Information Store cannot be accessed until the
backup finishes.
-mode online
Specify this option to perform an online backup by using Exchange Server 2003. Unlike a cold
backup, this option performs a backup without performing the following:
Mounting and unmounting the Information Store.
Switching the cluster resource (online and offline) in a cluster environment.
Mounting and unmounting the disk drive.
After performing a backup with this option, use the drmexgverify command to verify the integrity
of the backup data.
-mode vss
Specify this option to perform a backup by using VSS.
To use this option, the Protection Manager service must be running on the backup server.
Note
Basic commands184