HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.0 Mainframe Agent Installation and Configuration Guide (TB581-96014, November 2010)
• If you specify a storage group name and an Information Store name of the same storage group,
an error will occur.
• If you specify a storage group name and an Information Store name of different storage groups,
the backup data is restored in units of storage groups and Information Stores respectively.
• If you specify an Information Store name of data other than backup data obtained using VSS, an
error will occur.
• If you omit an Information Store name and specify storage-group-name\, an error will occur.
• When you want to specify an Information Store name, check the value displayed in INFORMA-
TIONSTORE of the drmexgcat command and specify exactly the same Information Store name.
• At restoration, this command dismounts all Information Stores within the storage group to which
the specified Information Store belongs.
• If the restoration target disk contains Information Store files that are not restoration targets, an error
will occur.
• If the restoration target disk contains data from different storage groups, an error will occur.
Return Values
0: Normal termination
Any value other than 0: Termination with an error
Examples
• In this example, the command is used to restore, by disk resynchronization, the backup data
identified by the backup ID 0000000001:
PROMPT> drmexgrestore 0000000001 -resync
KAVX0001-I The drmexgrestore command will now start.
KAVX1805-I The information store will now be dismounted.
Storage group name = STR1
KAVX1700-I Restore processing will now start.
KAVX1701-I Restore processing has finished.
KAVX1806-I The information store will now be mounted.
Storage group name = STR1
KAVX0002-I The drmexgrestore command will now end.
• In this example, the command is used to restore, by disk resynchronization, the backup data
identified by the backup ID 0000000003, and then performs a roll-forward recovery:
PROMPT> drmexgrestore 0000000003 -resync -recovery
KAVX0001-I The drmexgrestore command will now start.
KAVX1805-I The information store will now be dismounted.
Storage group name = STR1
KAVX1700-I Restore processing will now start.
KAVX1701-I Restore processing has finished.
KAVX1806-I The information store will now be mounted.
Storage group name = STR1
KAVX0002-I The drmexgrestore command will now end.
• In this example, the command is used to restore, by disk resynchronization, the backup data
identified by the backup ID 0000000005 with the seed function enabled, and then performs a
roll-forward recovery:
Basic commands210