HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 Administrator Guide (web) (TB581-96065, September 2011)

Defining the command device of the target storage system
Edit the perf_cmddev.properties file to define the command device of the target storage system.
The perf_cmddev.properties file is stored in the following location:
In Windows:
installation-folder-for-the-Device-Manager-agent\mod\hdvm\config\
perf_cmddev.properties
In Linux:
/opt/HDVM/HBaseAgent/mod/hdvm/config/perf_cmddev.properties
Use the following format to define the command device in the perf_cmddev.properties file.
Define one command device per line.
When using the Device Manager agent version 6.3 or earlier:
RAID-ID.serial-number.LDEV-number: deviceFileName
When using the Device Manager agent version 6.4 or later:
RAID-ID.serial-number.[SLPR-number.]LDEV-number: deviceFileName
The following table describes values to be specified in the perf_cmddev.properties file.
Table 53 Settings in the perf_cmddev.properties file
ValueSetting item
Specify one of the following depending on the type of the target storage
system:
R700 for HP P9500
R600 for HP XP24000
R601 for HP XP20000
R500 for HP XP12000
R501 for HP XP10000
R502 for SVS200
RAID-ID
Specify the serial number of the storage system by using a decimal
(base 10) number.
Serial-number
Specify the number of the SLPR to which the command device belongs
by using a decimal (base 10) number. If no SLPR is configured, specify
0.
This item is optional. If you omit this item or define this item by using
the format for version 6.3 or earlier, it is assumed that no SLPR has
been configured.
SLPR-number
Specify the CU:LDEV number of the command device by using a
decimal (base 10) number.
LDEV-number
Configuring Device Manager for CIM/WBEM156