HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 Administrator Guide (web) (TB581-96065, September 2011)

2. Restart the host OS.
3. Execute the HiScan command.
Reinstalling the Device Manager agent after a host OS upgrade
If you have installed the Device Manager agent and then upgraded the host OS under any of the
following conditions, perform an overwrite installation of the Device Manager agent:
• Upgrading Solaris from a version earlier than 9 to version 9 or later
• Upgrading AIX from a version earlier than 5.2 to version 5.3 or later
• Upgrading HP-UX from a version earlier than 11i v2 to version 11i v2 or later
Device Manager agent in a Windows host environment
This section provides notes that are specific to hosts using Windows.
Allocating device drives (Windows)
The Device Manager agent will not acquire data from devices assigned drive letter A or device
managed Device Manager agent.
Notes on when firewall settings are enabled (Windows)
To run a Device Manager agent on a computer on which Windows Firewall is active, you need to
register the following ports, which are used by the Device Manager agent, to the Windows Firewall
exceptions list:
• Port set for the server.agent.port property (default: 24041/tcp)
• Port set for the server.http.port property (default: 24042/tcp)
• Port set for the server.http.localPort property (default: 24043/tcp)
To register ports to the exceptions list:
1. Log on as a member of the Administrators group.
2. Use the firewall_setup command to add the ports used by the Device Manager agent to
the Windows Firewall exceptions list.
Device Manager agent in an AIX host environment
This section provides notes that are specific to hosts using AIX.
Registering Device Manager agent as a SED exception (AIX)
The Java process to be used by the Device Manager agent must be registered as an SED exception
by following the procedure below.
Using and maintaining the Device Manager agent210