HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 Administrator Guide (web) (TB581-96065, September 2011)

Default: true
client.rmi.port
This property specifies the port number for the Device Manager RMI server. You must specify the same
value as the one specified for the server.rmi.port property of the Device Manager server.
Default: 23055
client.migration.use.legacymode
This property specifies whether migrations that use migration groups created in version 7.1.0 or earlier
can be executed from the Tiered Storage Manager GUI.
To execute a migration that uses a migration group, specify true. Specifying true enables you to
open the window for migrations that use migration groups (Legacy mode GUI) by selecting Tools and
then Legacy Tiered Storage Manager.
If false is specified, you cannot perform migrations that use migration groups from the Tiered Storage
Manager GUI.
TIP:
• In version 7.1.1 or later, you no longer have to define migration-source volumes in a migration
group before performing migrations.
• Even when true is specified, migrations can still be performed by selecting Migrate Data from
the General Tasks tab or the Mobility tab, and then using the Migration Wizard to directly specify
the migration-source and migration-target volumes.
• Regardless of whether true or false is specified, you can use the Tiered Storage Manager CLI
to perform migrations using migration groups.
CAUTION:
If this property is set to false, any migration tasks created via migration groups cannot be referenced
or operated on from Tasks under the Task & Alerts tab. As such, make sure that there are no incomplete
migration tasks when changing the value of this property from true to false. If there are any
incomplete tasks, end the tasks via one of the following methods:
• Execute the tasks immediately.
• Cancel the tasks, change this property to false, and then recreate the tasks by using the Migrate
Data wizard.
Default: false
client.launch.HPPA.report.protocol
This property specifies the protocol included in the PA URL when launching the PA GUI. You can
specify either http or https. Specify this value by using only lower-case characters.
Default: None
Administrator Guide (Web Version) 329