HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 Administrator Guide (web) (TB581-96065, September 2011)

CAUTION:
If you specify false, filter conditions will not be checked so make sure that you enter correct filter
conditions. Normally, leave this property as the default value of true so that filter conditions are
checked.
server.migration.dataErase.defaultValue
This setting specifies the status of the Erase remaining data on source volumes. check box when the
Migration wizard is started, and the action to be taken when the erasedata parameter of the
CreateMigrationTask command is omitted.
Specify a Boolean value for this property.
If true is specified:
The Migration wizard starts with the Erase remaining data on source volumes. check box selected.
Also, if the erasedata parameter of the CreateMigrationTask command is omitted, the
command is executed assuming that Yes is specified.
If false is specified:
The Migration wizard starts with the Erase remaining data on source volumes. check box cleared
in the initial display. Also, if the erasedata parameter of the CreateMigrationTask command
is omitted, the command is executed assuming that No is specified.
To prevent data leaks, we recommend that you delete the data on migration source volumes after
migration.
Default: false
CAUTION:
If you modify this property value, you must restart the services of P9000 Command View AE Suite
products to enable the changes.
server.migrationPlan.candidateVolumeCountLimit
This setting specifies whether to limit the number of candidate volumes that are displayed when creating
a migration plan.
Specify a Boolean value for this property. If you specify true, the number of displayed candidate
volumes will be limited. If you specify false, there will be no limit imposed on the number of displayed
candidate volumes.
Default: true
server.migrationPlan.candidateCapacityGroupDisplayMaxCount
This setting specifies how many volumes with a larger capacity than the migration source volume to
display in addition to the volumes with the same capacity as the migration source volume when
creating a migration plan.
You can specify a value from 0 to 10. Specify 0 to display only volumes with the same capacity as
the migration source volume.
Administrator Guide (Web Version) 339