HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 Administrator Guide (web) (TB581-96065, September 2011)

For IPv6, specify the IP address using hexadecimal numbers with colons. Abbreviation can be
used. The following example shows how to specify an IPv6 address:
server.server.serverIPAddress=2001::214:85ff:fe02:e53b
When specifying a host name:
Use a character string of 50 bytes or fewer to specify the host name. The following characters
can be used:
a-z A-Z 0-9 - . @ _
Default: 255.255.255.255
server.server.serverPort
Specify the port number of the Device Manager server to which the Device Manager agent is going
to connect. As a general rule, you can specify a value from 1024 to 49151. You must specify the
same value specified for the server.http.port property of Device Manager server.
Default: 2001
server.agent.rm.centralizePairConfiguration
disable
Specify this value to manage copy pairs for each host when the system uses the local management
method. To use the local management method, you need to install the Device Manager agent
and RAID Manager on each host.
When the local management method is used, if you specify LUs as a copy pair that has different
hosts, make sure that each LU is recognized by each host.
enable
When the system uses the central management method, specify this value to manage all copy
pairs with a single host (pair management server). To use the central management method, you
must install the Device Manager agent and RAID Manager only in the pair management server,
and the Device Manager agent only in other hosts.
When the central management method is used, if the pair management server recognizes the
command device in each storage system, the server can use all LUs, including LUs that are not
recognized by the hosts of each storage system, to create copy pairs.
Default: disable
server.agent.rm.cuLdevForm
Specify the output format for LDEV numbers when pair volume information is written in HORCM_LDEV
format in the configuration definition file when creating pairs. If omitted, the information will be output
in decimal format.
DECIMAL
Specify to output in decimal format.
CULDEV
Specify to output in CU:LDEV format.
HEXA
Specify to output in hexadecimal format.
This property is enabled only when creating copy pairs for P9500, XP24000/XP20000.,
XP12000/XP10000/SVS200, or XP1024/XP128. In addition, if a virtual command device is used
Device Manager agent properties360