HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 Administrator Guide (web) (TB581-96065, September 2011)

#:
The host name must be resolvable to the IPv6 address.
CAUTION:
If XP24000/XP20000 storage or XP12000/XP10000/SVS200 storage that is managed via an IPv4
address is also set up as a Device Manager management-target, IPv4 addresses must also be set for
any NICs that have IPv6 addresses specified for the server.http.host property.
Settings for migrating Device Manager to an IPv6 environment
If Device Manager is used in an IPv4 environment and you then wish to use it in an IPv6 environment,
edit the httpsd.conf file. The httpsd.conf file is stored in the following locations:
• In Windows:
installation-folder-for-Common-Component\httpsd\conf\httpsd.conf
• In Linux:
installation-directory-for-Common-Component/httpsd/conf/httpsd.conf
CAUTION:
Stop the P9000 Command View AE Suite product services, and then edit the httpsd.conf file.
After editing the file, restart the P9000 Command View AE Suite product services to apply the changes.
NOTE:
If you perform a new installation of Device Manager in an environment where IPv6 is enabled, the
installer automatically sets the following settings.
IPv6 settings for migrating Device Manager to an IPv6 environment
Remove the hash mark (#) from the line that includes Listen [::]:23015 (the default setting). By
default, all IP addresses are set to allow communication.
Specify the same port number as specified in the Listen line for IPv4. The default value for the port
number is 23015.
The following shows an example of how to specify these settings:
Network configuration82