HP StorageWorks P9000 Replication Manager Software 7.1 CLI User Guide (TB584-96026, May 2011)

Setting communication timeout periods for the Protection Manager service
When an Exchange database is being backed up, you can specify the communication timeout period
for the Protection Manager service, using the following parameter.
Table 29 Parameter in init.conf (setting the communication timeout period for the Protection Manager
service)
Default
(specifiable value)
DescriptionParameter
1440
(0-10080)
Specify a number of minutes for the Protection Manager service
communication timeout period. If 0 is specified, no timeout is set.
In this case, if the Protection Manager service does not return a
response, the command that requested processing from the
Protection Manager service remains in the standby state.
If the parameter is not specified, 1440 is applied.
SER-
VICE_TIMEOUT
By specifying a communication timeout period for the Protection Manager service, you can avoid the
situation in which a Application Agent command remains in standby status and never terminates.
Note
If the SERVICE_TIMEOUT parameter is changed while a Application Agent command is executing,
the timeout time is not changed for the executing command.
Application AgentSetting up Application Agent for linkage
with RAID Manager
Do not set HORCMINST or HORCC_MRCF in the system environment variable. Also, do not set
HORCM_CONF or HORCMPERM in the system environment variable or the user environment variable.
For the RAID Manager settings, add or change the parameters in the RAID Manager-linkage definition
file (DEFAULT.dat). However, do not delete or modify the following parameters since they are used
internally by Application Agent:
• VENDER
• PRODUCT
The location of the RAID Manager-linkage definition file (DEFAULT.dat) is stored in the following
location:
Application-Agent-installation-folder\conf\raid
Note
Application Agent does not support RAID Manager's Protection Facility. If you link to RAID Man-
ager, disable its Protection Facility.
Specifying instance numbers
For parameters HORCMINST and HORCMINST_AUX, specify the instance number of the RAID Manager
instance. The specified instance number must be equal to the instance number used in the RAID
Manager configuration definition file name (n in horcmn.conf) on the server.
Notes
Preparation for using Application Agent118