HP StorageWorks P9000 Replication Manager Software 7.1 CLI User Guide (TB584-96026, May 2011)

Specifiable val-
ues
(default)
DescriptionParameter
0 to 3600
(Value of
RETRY_TIME)
Specifies the maximum number of times a retry
can be performed for checking whether
resynchronization on restoration has finished.
If you specify 0, Application Agent continues
to retry checking until it succeeds in checking
the pair status.
When adding this parameter, make sure that
the product of the RESTORE_RETRY_TIME-value
and RESTORE_RETRY_WAIT-value is sufficiently
larger than the time required to complete
resynchronization.
RESTORE_RETRY_TIME
0 to 360000
(Value of
RETRY_WAIT)
Specifies the retry interval for checking whether
resynchronization on restoration has finished.
You can specify a value in units of 10
milliseconds.
When adding this parameter, you must
consider the following: the number of disks to
be restored, the disk sizes, and the difference
in data amount between the primary and
secondary volumes when at the time the
restoration is performed
#2
.
RESTORE_RETRY_WAIT
0 to 3600
(Value of
RETRY_TIME)
If restoration is performed immediately after a
backup, from a generation that is different from
the primary volume backed up, some time may
be required until the volume becomes ready for
resynchronization.
Specify the maximum number of retries that will
be performed to confirm whether the volume is
ready for resynchronization. You need to
specify this parameter if you want to check
whether the pair status allows execution of
pairresync -restore for restoration. If you
specify 0, Application Agent continues to retry
checking until it can check the pair status.
When adding this parameter, make sure that
the product of the
RESTORE_DELAY_RETRY_TIME-value and
RESTORE_DELAY_RETRY_WAIT-value is
sufficiently larger than the time required until
synchronization between the primary and
secondary volumes is completed on the storage
system.
RESTORE_DELAY_RETRY_TIME
Preparation for using Application Agent124