HP StorageWorks P9000 Replication Manager Software 7.1 CLI User Guide (TB584-96026, May 2011)

Application-Agent-installation-directory\conf
Table 48 vsscom.conf Parameters
Values that can be setDescriptionParameter
1 to 256 one-byte charac-
ters
Specifies the host name or IP
address of the backup server.
BACKUP_SERVER
0 to 99999
Specifies the number of times
backup is retried if a Writer
timeout occurs during backup.
If 0 is specified, backup is not
retried. The retry count should
be increased in the following
cases:
• The error message
KAVX5004-E appears
during backup.
If file system backups are
taking a long time, check the
disk configuration details in
“Using VSS” on page 82.
If Exchange database
backups are taking a long
time, check the disk
configuration details in “Using
VSS” on page 91.
WRITER_TIMEOUT_RETRY_COUNT
0 to 99999
Specifies, in seconds, the in-
tervals at which backup is re-
tried when a Writer timeout
occurs. Usually, this paramet-
er does not need to be
changed.
WRITER_TIMEOUT_RETRY_INTERVAL
0 to 99999
Specifies the number of times
backup is retried when a
verification error occurs in the
Exchange database contain-
ing the backup results. If 0 is
specified, backup is not re-
tried. Usually, this parameter
does not need to be changed
This value is not required
when the backup is of a file
system.
EXG_VERIFY_RETRY_COUNT
0 to 99999
Specifies, in seconds, the in-
tervals at which backup is re-
tried when an Exchange
database verification error
occurs. Usually, this paramet-
er does not need to be
changed This value is not re-
quired when the backup is of
a file system.
EXG_VERIFY_RETRY_INTERVAL
CLI User Guide 149