HP StorageWorks P9000 Replication Manager Software 7.1 CLI User Guide (TB584-96026, May 2011)

Application-Agent-installation-directory\conf\tape\NBU_sample.dat
• Backup Exec
Application-Agent-installation-directory\conf\tape\BEWS_sample.dat
Configuration parameters
The parameters in the configuration definition file for tape backup are in the order indicated in the
table below.
Table 55 Parameters to be defined in the configuration definition file for tape backup (for NetBackup)
DescriptionParameter
Specify the absolute path in which NetBackup is installed (use a maximum of
1,024 bytes).
INST_PATH
Specify the NetBackup master server name used to query the backup target
(maximum of 255 bytes). Specify a host name that can be resolved by the OS or
an IP address (IPv4). If this parameter is omitted, the name of the host that executed
the command is used as the NetBackup master server name. This parameter is
applicable when NetBackup 6.5 or later is used.
NBU_MASTER_SERVER
Specify whether the include command can be executed (maximum of 8 bytes).
This parameter is not case sensitive.
• If YES is specified
Application Agent registers the backup target path in the policy (class) by ex-
ecuting NetBackup's bpplinclude or bpclinclude command. After execut-
ing the drmmediabackup command, Application Agent deletes the backup
target path that was registered in the policy (class). Application Agent also
registers the backup target media information in the backup catalog.
• If a character string other than YES is specified
Application Agent does not register the backup target path in the policy (class),
and the user must use NetBackup to register the backup target path in the
policy (class).
When this parameter is omitted, the result is the same as when YES is specified.
You can specify this parameter when you use NetBackup 6.5 or later.
INCLUDE_EXEC
CLI User Guide 157