Manualshelf

HP XP P9000 Replication Manager Software 7.6.0-00 Application Agent CLI User Guide

ManualsBrandsHP ManualsSoftwareHP XP Array Manager Enterprise Media Kit
481482483484485486487488489490
10. From the backup server, back up the data on the secondary volume to a tape device.
An unused backup ID (0000000002) is assigned.
PROMPT> drmmediabackup 0000000001
KAVX0001-I The drmmediabackup command will now start.
KAVX0402-I Backup processing will now start.
To see more details on backup progress, use the monitoring
method of
the backup management product.
Source = W:
KAVX0402-I Backup processing will now start.
To see more details on backup progress, use the monitoring
method of
the backup management product.
Source = X:
KAVX0403-I Backup processing has finished.
Source = W:
KAVX0403-I Backup processing has finished.
Source = X:
KAVX0040-I The backup ID has been assigned as follows:
Backup ID = 0000000002
KAVX0002-I The drmmediabackup command will now end.
PROMPT>
11. Confirm that the backup to the tape device was successful.
From the backup server, check to see if the backup to the tape device has successfully completed:
PROMPT> drmtapecat -backup_id 0000000002
BACKUP-ID BACKUP-OBJECT SNAPSHOT TIME EXPIRATION TIME BACKUP-MEDIA
0000000002 MSEXCHANGE 2002/06/01 11:00:00 2002/06/02 11:00:00 MEDIA1
PROMPT>
12. Unmount the secondary volume where the backup data is stored.
Specify the backup ID that was assigned when the backup was imported (0000000001) to
unmount the secondary volume.
PROMPT> drmumount 0000000001
KAVX0001-I The drmumount command will now start.
KAVX0406-I Unmounting will now start.
Mount point = W:
KAVX0407-I Unmounting has finished.
Mount point = W:
KAVX0406-I Unmounting will now start.
Mount point = X:
KAVX0407-I Unmounting has finished.
Mount point = X:
KAVX0002-I The drmumount command will now end.
PROMPT>
Roll-forward recovery on backed up data acquired in an SCR configuration
This section provides an example of how to perform a roll-forward recovery on a storage group, using
backed up data that was acquired in an SCR configuration. This example uses the backup data
acquired in “Backing up in an SCR configuration” on page 478.
1. From the backup server, start the Protection Manager service.
Operation for Exchange databases482