HP XP P9000 Replication Manager Software 7.6.0-00 User Guide

27 Replication Manager CLI tools

This chapter describes the CLI functions supported by Replication Manager.

About the installation base path

If the XP P9000 Command View AE Common Component is not installed under the installation directory

of XP P9000 Command View AE suite products, you must set the HRPM_CLI_BASE_PATH environment

variable to the actual installation path. Typical cases where this environment variable setting is

necessary are:

• An XP P9000 Command View AE suite product is installed in an environment where Common

Component has already been installed by another product.

• An XP P9000 Command View AE suite product is upgraded to 7.4 or later in an environment

where the Common Component has already been installed by another XP P9000 Command View

AE suite product earlier than 7.0.

If the HRPM_CLI_BASE_PATH environment variable has not been set correctly, the Replication

Manager CLI will generate a KAVN00189-E error. If you see this error after executing a command,

check the value of HRPM_CLI_BASE_PATH.

Using the GetCTDelta command

In addition to the Replication Manager GUI, you can also export C/T Delta (write delay) history data

from the command line. Using the GetCTDelta command, you can output the histories of all (or

select) copy groups to a CSV-format file or the console. The command line is an alternative to generate

the information quickly without the overhead associated with the GUI.

GetCTDelta output is in CSV format. Histories are output from the time of execution up until the date

specified by the command. The CLI output is the same as that exported from the GUI.

This topic contains the includes the following:

• Requirements, page 445

• Location, page 446

• Syntax, page 446

• Examples, page 447