HP XP P9000 Replication Manager Software 7.6.1-00 Application Agent CLI User Guide

If you specify an absolute path that begins with the drive letter as a mount point directory name
in the -mount_pt option, the mount point should be absolute-path-specified-as-a-mount-point-
directory-name\mount-point-in-the-copy-group-mount-definition-file
For example, when W:\ is specified in the -mount_pt option and FS=D:\ is specified in the
copy group mount definition file, the system mounts the unoccupied drives from the W drive. When
W:\mnt is specified in the -mount_pt option and FS=D:\mnt is specified in the copy group
mount definition file, the mount point will be W:\mnt\D\mnt.
Determination of a mount target
The following table describes how Application Agent determines a secondary volume (copy group)
to be backed up when executing the command for mounting a second volume.
Table 53 How to determine a mount target when the command for mounting a secondary volume is
executed
Secondary volumes to be
backed up (copy group)
Copy group mount
definition file
Disk type
An option specified at the
command execution
Copy groups that have been
recorded in the backup
catalog corresponding to
the specified backup ID
Not distinguishedAny disk typeBackup ID
Copy groups specified by
the -copy_group option
Not distinguishedBasic disk
-copy_groupcopy-group-
name
All copy groups that make
up the same disk group (disk
set)
Yes
Dynamic disk
Terminate in errorNo
Legend:
Yes: The definition file exists.
No: The definition file does not exist.
Preparations required before executing extended commands
This section explains preparatory steps you must perform before executing extended commands. The
following figure and tables gives an overview of the preparations required before executing extended
commands, and the tasks needed for each kind of server.
Table 54 Extended command execution preparation tasks needed for each kind of server
Location in this
manual
Backup
server
File server or
database server
Tasks
Checking the pre-
requisite condi-
tions, page 183
NeededNeededCheck the prerequisite conditions
Setting up an FTP ser-
vice for backing up to
tape, page 185
NeededNot needed
Set up an FTP service (if you are going to back
up to tape).
Preparation for using Application Agent182