HP XP7 Command View Advanced Edition Administrator Guide (Web Version) (TK981-96004, May 2014)

CAUTION:

An IP address on the network to which the management client is connected (10.0.0.100 in Figure

16) must be specified for the HP XP7 Command View Advanced Edition product settings below. Do

not specify a host name.

• The setting for the computer on which the Device Manager Web server function is running (the

server.http.host property)

Related topics

• hdc.service.rmi.registryIPAddress, page 371

Device Manager settings in IPv6 environments

Device Manager supports IPv6-based communication. To use Device Manager in an IPv6 environment,

you need to change the Device Manager settings according to the environment's requirements.

To use Device Manager in an IPv6 environment, make sure that the Device Manager settings meet

the following requirements:

• Set up the OS so that both IPv6 and IPv4 can be used because, even if IPv6 is being used, IPv4

is also required for processing in the product.

• You can only use global addresses as IPv6 addresses. Global-unique local addresses (site-local

addresses), and link-local addresses cannot be used.

• When specifying the IP address or host name of the Device Manager server, HP recommends that

you use the host name.

Settings for migrating Device Manager to an IPv6 environment

If Device Manager is used in an IPv4 environment and you intend to use it in an IPv6 environment,

edit the user_httpsd.conf file.

NOTE:

If Device Manager is installed as a new installation in an IPv6 environment, the procedure described

below is not necessary because the installer automatically changes the settings.

Administrator Guide (Web Version) 87