HP XP7 Replication Manager Application Agent CLI User Guide (TK981-96015, May 2014)

• Write parameters in the form parameter-name=parameter-value.
• Use an equals character (=) between a parameter name and a parameter value.
• Specify a parameter value within the valid range.
The following values can be specified in copy parameter definition files.
Table 28 Parameter in copy parameter definition files
Specifiable valuesDescriptionParameter
0 to 3600
In this parameter, specify the
maximum retry count for checking
the status of a pair. If you specify
0, Application Agent continues to
retry checking until it can check
the status.
RETRY_TIME
0 to 3600
In this parameter, specify the
same number of seconds as the
retry interval for checking the
status of a pair.
RETRY_WAIT
0 to 3600
Specifies the maximum number
of retries for checking the comple-
tion of pair resynchronization.
RESYNC_RETRY_TIME
0 to 360000
Specifies the retry interval for
checking the completion of pair
resynchronization (in units of 10
milliseconds).
RESYNC_RETRY_WAIT
0 to 3600
Specifies the maximum number
of times a retry can be performed
for checking whether pair splitting
has finished.
SPLIT_RETRY_TIME
0 to 360000
Specifies the retry interval for
checking whether pair splitting
has finished. You can specify a
value in units of 10 milliseconds.
SPLIT_RETRY_WAIT
0 to 3600
Specify the maximum number of
times a retry can be performed
for checking whether resynchron-
ization on restoration has fin-
ished.
RESTORE_RETRY_TIME
0 to 360000
Specifies the retry interval for
checking whether resynchroniza-
tion on restoration has finished.
You can specify a value in units
of 10 milliseconds.
RESTORE_RETRY_WAIT
Preparation for using Application Agent122