HP XP7 Replication Manager Application Agent CLI User Guide (TK981-96015, May 2014)

Specifying the installation path for RAID Manager
Specifying the installation destination for the RAID Manager commands to be started by Application
Agent.
If RAID Manager is to be installed on a different drive than Application Agent, specify the installation
destination for RAID Manager.
If RAID Manager is to be installed on the same drive as Application Agent, the installation path for
RAID Manager is set automatically when Application Agent is installed.
Table 33 Parameter in the RAID Manager-linkage definition file (DEFAULT.dat) (specifying the installation
path for RAID Manager)
DefaultDescriptionParameter
system-drive\HORCM
If RAID Manager is to be installed on a different drive
than Application Agent, specify the installation destina-
tion for RAID Manager.
INSTALLPATH
Specifying modification of pair status if a backup error occurs
You can set up the system so that if an error occurs during backup command processing, the system
modifies the status of the pair in the COPY or PAIR status to the PSUS status before command processing
terminates
#
. By specifying this setting, you can avoid the problem of degradation in online I/O
performance that results when processing terminates because of an error during online (especially
VSS) backup.
#
If the backup is performed in a cascade configuration, this setting is disabled for a remote site.
Table 34 Parameter in the RAID Manager-linkage definition file (DEFAULT.dat) (specifying modification
of the pair status if an error occurs)
Specifiable
values
(default)
DescriptionParameter
ASIS or
PAIRSPLIT
(ASIS)
Specifies whether the pair status is to be modified
if an error
#
occurs during backup processing. If
SQL Server is used and, in the Application Agent
configuration definition file (init.conf), 1 is
set for SQL_QUICK_BACKUP, this parameter is
ignored.
If you specify ASIS, the pair status is not modified
if a backup error occurs.
If you specify PAIRSPLIT, the pair status is
modified to PSUS if a backup error occurs.
RECOVERY_MODE_ON_BACKUP_ABORT-
ING
#
Indicates an error that occurs after the message KAVX5167-I is output (indicating that the setting
for changing the pair status is valid) during backup processing. This setting is invalid if an error
occurs before the KAVX5167-I message is output. In this case, the pair status is not modified
even if PAIRSPLIT is specified.
Application Agent CLI User Guide 127