HP XP7 Replication Manager Application Agent CLI User Guide (TK981-96015, May 2014)

#2
This command can be executed with the drmresync command only when all of the following
conditions are satisfied:
• In Application Agent, the drmsqlbackup command has been executed for the target instance.
• The -no_cat option is not specified.
• The -v option is not specified.
• The -lsn option is not specified.
• The -d option is not specified.
• The instance name is specified.
Table 93 Possibility of concurrent execution with other commands (when the backup is of an Exchange
database)
Possible to run
with other com-
mands?
Function summaryCommand
NoBacks up an Exchange database to a disk.
drmexgbackup
Yes
Displays a listing of the backup information for an Exchange
database.
drmexgcat
Yes
#
• Displays a listing of Exchange database information.
• Updates the storage group information in the dictionary
map files.
drmexgdisplay
NoRestores an Exchange database.
drmexgrestore
No
Verifies consistency between an Exchange database and
backup information.
drmexgverify
Legend:
No: These commands cannot execute concurrently with other commands marked by No.
Yes: These commands can execute concurrently with any other command (marked by Yes or No).
#
This command cannot be executed with other commands when the -refresh option is specified.
This command can be executed with other commands when other options are specified.
Retry time when an error occurs
When an error occurs, the system retries the command. Therefore, command execution may take
some time (the additional time needed to retry the command). The command retry interval and the
number of times to retry depend on the values set in the xxx_RETRY_TIME and xxx_RETRY_WAIT
parameters in the Application Agent configuration definition file (init.conf) and RAID Manager
linkage definition file (DEFAULT.dat). Depending on the values set in these parameters, more than
the usual amount of time may be required for executing a command if an error occurs.
Stopping retry operations caused by a command that cannot execute concurrently
with other commands
While a command is executing, if a user attempts to execute another command that cannot be executed
concurrently with the executing command, the system will attempt to execute the latter command
Application Agent operations240