HP StorageWorks P9000 for Business Continuity Manager Software Installation Guide (T5253-96052, May 2011)

The storage destinations for sample jobs are shown below:
• When installed from installation tape
The sample JCL is stored in a dataset at the destination for the copy operation described in
section “Preparations for Installing Business Continuity Manager from a Tape” (page 20).
• When installed from CD-ROM
The sample JCL is stored in the HP.CHYLnnn.F1 dataset (the nnn portion varies depending
on the version) after the procedure in “Preparations for Installing Business Continuity Manager
from a CD-ROM” (page 21) is executed. If the RECVUPLD job is changed and the output
destination dataset name for the TSO/E RECEIVE command is changed, the sample JCL is
stored in the dataset after the changes.
JCL member names and functions are shown below. The following sample JCL is executed during
a simple installation.
• HPQYKSIN
Copies the content of the provided datasets to the target library.
For examples of modifying sample JCL (HPQYKSIN), see “HPQYKSIN (Simple Installation)”
(page 92).
Setting up the environment
This section describes how to set up a Business Continuity Manager environment ( “Items that must
be performed for environment setup” (page 24) lists the items that must be performed to set up the
environment). Perform these items in the order listed in the table.
Table 12 Items that must be performed for environment setup
See:DescriptionItemItem
order
“Settings for Using CLI Commands in TSO/E
Environments” (page 25)
Settings needed for using CLI commands in
TSO/E environments
Settings for using CLI
commands in TSO/E
environments
1
“Settings for using ISPF panels with Business
Continuity Manager” (page 25)
The YKSTART command must be configured
to use ISPF panels with Business Continuity
Manager.
Settings for using ISPF
panels with Business
Continuity Manager
2
“Settings for using the YKWATCH command
and the copy group definition generation
function for PPRC copy pairs” (page 27)
YKWPROC must be configured for executing
the YKWATCH command and the copy group
definition generation function for PPRC copy
pairs as background jobs.
Settings for using the
YKWATCH command and
the copy group definition
generation function for
PPRC copy pairs
3
“ Settings for Using Environment Configuration
Commands” (page 27)
Settings needed for using the following
environment configuration commands:
• YKALCSVC command: Registers a user
supervisor call interruption.
• YKSETENV command: Sets the Business
Continuity Manager environment variables.
• YKDSPENV command: Displays the
Business Continuity Manager environment
variables.
Settings for using
environment configuration
commands
4
“Setting the Security” (page 31)Security settings for environment configuration
commands, CLI commands, and datasets
Setting security5
“Setting security for the environment
configuration commands” (page 31)
User supervisor call interruption registrationRegistering a user
supervisor call interruption
(SVC)
6
24 Installing Business Continuity Manager