HP StorageWorks P9000 for Business Continuity Manager Software Installation Guide (T5253-96052, May 2011)

NOTE:
• If you use BCM to change a configuration file while storage information is being acquired by
P9000 Replication Manager, a configuration file allocation error may occur. If this happens,
use BCM to again change the configuration file.
• If storage information is being acquired by P9000 Replication Manager while a configuration
file is being updated by BCM, an error may occur. If this happens, the information is acquired
when it is next requested (at the fixed interval set in P9000 Replication Manager).
General Procedure for Setting Up an Environment for Business Continuity Manager
Agents
The following sections describe the general procedure for configuring the environment settings
necessary for linking with P9000 Replication Manager.
Configuring the Environment Settings Without Using the Remote DKC Control Function
(New BCM Installation)
Figure 4 (page 51) shows the general procedure for configuring the environment settings starting
from before BCM is installed, without using the Remote DKC Control Function.
Figure 4 Configuring the Environment Settings Without Using the Remote DKC Control Function
(New BCM Installation)
Overview of environment settings 51