HP P9000 Replication Manager Software 7.3.1-00 Configuration Guide

NOTE:
When attempting to delete copy pairs from a Cnt Ac-J x Cnt Ac-J configuration for a mainframe
system, switch the status of all the copy pairs in the concatenated copy groups of the two instances
to Suspend, and then delete the copy pairs.
Restrictions on using HP StorageWorks P9000 for Business Continuity Manager Software 6.6.1
The following operations are not supported if you are using HP StorageWorks P9000 for Business
Continuity Manager 6.6.1:
• When using HP StorageWorks P9000 for Business Continuity Manager 6.6.1, if a volume scan
using Replication Manager is performed, an error (RPM-00539) occurs in Replication Manager.
• When Replication Manager is used to distribute disk configuration definitions files to a host linked
with HP StorageWorks P9000 for Business Continuity Manager 6.6.1, an error occurs (RPM-
00568) in Replication Manager.
In either of the above cases, Replication Manager cannot be used to edit the disk configuration
definition files that were created by HP StorageWorks P9000 for Business Continuity Manager 6.6.1.
Instead, you must use HP StorageWorks P9000 for Business Continuity Manager 6.7 or later to edit
the disk configuration definition files and then perform volume scan or distribution with Replication
Manager).
Supported storage systems
Replication Manager supports all storage systems supported by Device Manager server:
• XP512/XP48
• XP1024/XP128
• XP12000/XP10000/SVS200
• XP24000/XP20000
• P9500
For details, see the HP P9000 Command View Advanced Edition Suite Software Administrator Guide.
TIP:
For best results, ensure that you have the latest version of the storage system microcode as well as
the latest version of P9000 RAID Manager installed.
NOTE:
Before using copy groups defined in storage, ensure that the microcode version of the P9500 system
is 70-02-00-XX/XX or later.
Configuration Guide 41