HP P9000 Replication Manager Software 7.3.1-00 Configuration Guide

2 Setting up Replication Manager
This chapter explains how to set up and configure Replication Manager.
Overview
This section is an overview that lists all the tasks that need to be performed.
To set up and configure Replication Manager:
1. Before installing Replication Manager, you must back up the databases of other P9000 Command
View AE suite products in use, on the management server where Replication Manager is installed.
For details about how to back up databases, see the application product manuals.
2. Set up the necessary infrastructure as described in “Setting up the prerequisite
environment” on page 47.
3. For a cluster environment, follow the appropriate procedure in the HP P9000 Command View
Advanced Edition Suite Software Administrator Guide before installing Replication Manager.
NOTE:
After installing or updating Replication Manager, you must back up the new configuration data.
Setting up the prerequisite environment
This section describes how to set up the necessary infrastructure for Replication Manager. You can
follow the workflow figures or the detailed procedures. Skip any task that has already been completed.
• Open systems environment, page 48
• Mainframe systems environment, page 50
• Application replica environment, page 52
The following figure is an overview of the configuration procedure for both mainframe and open
systems.
Configuration Guide 47