HP P9000 Replication Manager Software 7.3.1-00 Configuration Guide

Default value
(unit)
PropertyFile
30 (seconds)
appagentif.connectTimeout
appagentif.properties
3600 (seconds)
appagentif.responseTimeout
true
base.repositry.synchronize.polling
base.properties
120 (seconds)
base.taskscheck.interval
0 (times)
base.taskscheck.maxcount
120 (seconds)
base.taskscheck.mf.interval
0 (times)
base.taskscheck.mf.maxcount
truebase.alert.automarking
1
base.refreshdginfo.exec
10 (minutes)
base.repositry.synchronize.interval
10 (minutes)
base.repositry.synchrocheck.interval
logger.properties
The logger.properties file is used to specify the values of log output-related properties. If a value
is not specified in the logger.properties file, or if the specified value is outside the specifiable
range, the default value will be used. The following table describes the available properties and
settings.
NOTE:
File size values must be specified in bytes, kilobytes, or megabytes. If the specified value is not followed
by KB or MB, the size is assumed to be in bytes. Specifiable values are determined by the specified
unit as follows:
Bytes: 4096 to 2147483647
KB: 4 KB to 2097151 KB
MB: 1 MB to 2047 MB
Table 46 List of properties in the logger.properties file
DescriptionProperty
The threshold value for the output level of the
Replication Manager log files. Messages containing
values that are equal to or less than this value are
output to the log file.
Specifiable values: 0, 10, 20, 30 (in decreasing
order of importance from left to right).
Default value: 20
logger.loglevel
Operating the management server88