HP P9000 Replication Manager Software 7.3.1-00 Configuration Guide

DescriptionProperty
The maximum number of times that Replication Manager checks the
processing status of a Device Manager Agent when Device Manager
Agent takes an indefinite period of time to collect configuration
information or to perform copy pair operations. If 0 is specified,
there is no limit on the number of retries.
Specifiable values: 0 to 100 (times)
Default value: 50
hdvmagtif.MaxPollingCount
The interval at which Replication Manager checks the processing
status of a Device Manager Agent when Device Manager Agent
takes an indefinite period of time to collect configuration information
or to perform copy pair operations.
Specifiable values: 5 to 1200 (seconds)
Default value: 30
hdvmagtif.PollingInterval
appagentif.properties
The appagentif.properties file is used to specify the values of properties necessary for the
interface between Replication Manager and Application Agent. Normally, you do not need to change
these values. To change the values, you need expert knowledge of Application Agent. The following
table describes the available properties and settings.
Table 51 List of properties in the appagentif.properties File
DescriptionProperty
The amount of time Replication Manager waits to connect to an
Application Agent when collecting configuration statuses. If 0 is
specified, Replication Manager waits until a connection is
established without timing out.
Specifiable values: 0 to 3600 (seconds)
Default value: 30
appagentif.connectTimeout
The amount of time Replication Manager waits to receive a
response from an Application Agent when collecting configuration
statuses. If 0 is specified, Replication Manager waits for a
response without timing out. If the specified value exceeds the
maximum, the default value is used.
Specifiable values: 0 to 86400 (seconds)
Default value: 3600
appagentif.responseTimeout
Operating the management server94